EARLY PARTS NEEDED for SA 8-40

[Nodak71]

I recently worked on a SA from 8-40. I have discovered I need some internals for this thing to be half way right. I need a "flat back" follower arm if anyone has one, hadn't heard or ever seen one until I looked at some pictures posted on this site. I also need a couple of the later op rod catches w/o finish. I could also use a follower with the unmodified slide, I think I was told I needed one of the "wide tail" type. I know, good luck. I'm not even going to ask about a no trap equal hole SPG stock. I am posting here since there seem to be a number of knowledgeable advanced collectors on this site. Thanks for looking.

I have obtained the follower arm, follower, and ONE op rod catch.


Have found the small parts I needed, thanks

[Jersey Devil]

I have a flat-back follower arm for you.

[Nodak71]

Ok sounds good, PM sent.

[Nodak71]

I think I have found what I needed with the exception of a SPG stock which is good luck finding one of those without breaking the bank. Thanks to all