If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
Do you think these gages have anything to do with the Garand? The long gages are min .2066 max and one is min .2060. They fit in the the hole of the square gage. The gage on the firing pin hole are .083 and .080 I assume max and min. No go gages normally measure .084. The square gage is dated 2-15-40.