Win13 op rod

[saa man]

Can anyone tell me the absolute correct op rod for a winchester win13 garand serial #16078xx …
I have a CMP really nice garand with a lot of Winchester parts but unfortunately it has a SA op rod and I want to replace it with the correct one…Also if this is permitted, where would I be likely to find the correct one??
Thanks

[1563621]

Look for a WRA that is not an angle cut. That is the correct oprod.

[Orlando]

D35382 W.R,A. straight cut, flat side

[Arnhem44mad]

Any WRA Operating Rod is fine as lone as there is no Dash.

Scott

[lapriester]

Unless things have changed. Straight cut Win13 op rods are very difficult to obtain and very expensive to buy. I sold one years ago for more than $300.

[Potatopotate]

Anyone have a picture of the "straight cut" OP rod? I am not sure what should be straight VS angled. I looked at pictures online, but they all look the same to me ?

[jak]

Anyone have a picture of the "straight cut" OP rod? I am not sure what should be straight VS angled. I looked at pictures online, but they all look the same to me ?

Dupage has a Winchester op rod for sale. It has the slant cut.

https://www.dupagetrading.com/produc...operating-rod/

A Win13 op rod looks just like any post war op rod.

[Arnhem44mad]

Dupage has a Winchester op rod for sale. It has the slant cut.

https://www.dupagetrading.com/produc...operating-rod/

A Win13 op rod looks just like any post war op rod.

Not always mate. Some Slant cuts were used. It's the lack of - (dash) between the D35382 and WRA which denotes being of Win 13 production.

[Arnhem44mad]

Anyone have a picture of the "straight cut" OP rod? I am not sure what should be straight VS angled. I looked at pictures online, but they all look the same to me ?

[CCyooper]

Here are 2 WRA’s. A Win-13 top and a 2.5m