Announcement

Collapse
No announcement yet.

M-1 Safety trouble

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

    M-1 Safety trouble

    M-1 Safety Is a bear to put on and off I did read some articles about it I Took the trigger apart and Greased it where they told me to but still the same thing I found the hook when it goes over the top with a hammer to lock If I hold the hammer down a little it works perfect but if I released a hammer it’s a very hard safety any Tricks or ideas thanks Rye FYI it’s a CMP special that I bought from my future son-in-law Springfield Armory 3000,000 number built in January 1945

    #2
    The safety is working correctly. The trigger assembly was designed to not let the safety engage until the hammer is locked down. If you can actually engage the safety while the hammer is in the fired position then either the tip of the safety is broken off or the lug on the hammer is worn down to the point where it lets the safety engage.

    Comment


      #3
      I have run into the same problem. Try a different safety or hammer and see if this helps.

      Comment


        #4
        Check to see if its a commercial safety, they are known for this

        Comment

        Working...
        X