Ejection Problems with a SLED clip.

[Mrhunterken]

Gentlemen, my Garand is H&R and has been as far as I can tell, been completely reworked including a new Criterion barrel. It functions correctly with an 8rnd. en-bloc clip. Ejection is very positive with both empty brass and expended clips. My problems start when wanting to single load with a SLED clip. When pushing all the way in, it does not want to stay seated. And the times I get it to stay in the rifle, it ejects itself when I seat the one round to shoot. I could use some advice from the people who know more than I do to solve my issue. Thank You for your Assistance

[TJT]

Generally there is a tab on the left side that locks it in place between the receiver legs. It may need to bent outward a LITTLE bit. You should need a knife point or small screw driver to get it out. At least that's how mine works.
Jon

[Mrhunterken]

OK TJ, I'm not exactly sure about what you mean, but i'll check it when I have a few minutes. I don't remember seeing any tabs anywhere between the receiver legs.

[Mrhunterken]

TJ, I'm sorry, I looked and did not see what I think i'm supposed to see. Can you elaborate?

[TJT]

If you can pm me your phone number or email, I'll take a picture of it and send or text it to you. I have to use my phone 'cause my computer is on the fritz and I haven't figured out yet how to send a pic from my phone to a forum.
Jon

[Mrhunterken]

Generally there is a tab on the left side that locks it in place between the receiver legs. It may need to bent outward a LITTLE bit. You should need a knife point or small screw driver to get it out. At least that's how mine works.
Jon

TJ, Thank You for your assistance, I finally got it through my thick skull that you were talking about the SLED itself, and not the receiver of my rifle. MY Bad

[TJT]

Glad you got it figured out.
Jon