If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
Thanks for post my photo Brian, I was attempting to locate any serial number range where a A marked trigger was used. Also keep in mind that there was both the A with serifs and the A without serifs too. The revision 2 triggers had the thin trigger then there was a thin trigger but unmarked but the A marked triggers have the thicker trigger profile. Most of the time you can spot the A marked trigger inside the trigger housing as enough of the A is exposed to view.
As a note: the thin trigger profile was also used on the early Model 1903 rifle before changes
Not many Winchester triggers with the extra hole and A marked (I have one ) All the A marked Winchester triggers that I have seen have a larger size A which is also very thin and located to the rear of the trigger
Comment